HomeTechnical Support » Configuration & Setup

Configuration & Setup

Moving Payee Information down Messages in this topic - RSS

RobertSheridan
Posts: 2


6/24/2021
RobertSheridan
Posts: 2
Brian wrote:
Robert, the best solution here will depend on what version of Sage you're using. Are you using Sage 300 Construction and Real Estate, or Sage 300 ERP? If it's the former, you should be able to edit the payee information on the check form using the editor in the work file view. If you go to File -> Open Document Workfiles, and select the form (usually either TMBR_AP4 or TL_AP5 for AP checks), and then click "Browse" and then "View", you should be able to see what the checks look like. You should then be able to just drag and drop the top line of the payee information and the lines beneath it should automatically follow with them. Then save the changes and all future checks should print that way.


You rock! This worked perfectly, now we don't have print out labels when we do a check run. Thank you very much!
0 link
Brian
Administrator
Posts: 24


6/24/2021
Brian
Administrator
Posts: 24
Robert, the best solution here will depend on what version of Sage you're using. Are you using Sage 300 Construction and Real Estate, or Sage 300 ERP? If it's the former, you should be able to edit the payee information on the check form using the editor in the work file view. If you go to File -> Open Document Workfiles, and select the form (usually either TMBR_AP4 or TL_AP5 for AP checks), and then click "Browse" and then "View", you should be able to see what the checks look like. You should then be able to just drag and drop the top line of the payee information and the lines beneath it should automatically follow with them. Then save the changes and all future checks should print that way.

--
Wellspring Software
Support Technician
+1 link
RobertSheridan
Posts: 2


6/24/2021
RobertSheridan
Posts: 2
Hi, I am relatively new to PrintBoss, we use it to cut checks out of Sage. The problem I am having is that our the payee name and address is too high on the blank check stock. I need to move it down so that it fits in the envelope window. I can't seem to find out how to do this. I played around with changing the "Non-MICR" settings but it didn't work. Thanks in advance!
0 link






Powered by Jitbit Forum 8.3.8.0 © 2006-2013 Jitbit Software